Eclipse GT V6-3.0L SOHC (2000)
Required Special Tool:
MB991223: Test Harness Set
STEP 1. Check the windshield wiper motor
1. Disconnect the wiper motor connector A-03.
2. Run the wiper motor at low-speed, disconnect the battery, and stop the motor.
3. Reconnect the battery as shown in the illustration, and confirm that after the motor starts turning at low-speed, and stops at the automatic stop
position.
If the wiper motor is damaged, replace the wiper motor. The windshield wiper should stop at the predetermined park position.
If the wiper motor is in good condition, go to Step 2.
STEP 2. Check the wiper motor power supply circuit at the wiper motor connector A-03.
1. Disconnect the wiper motor connector A-03 and measure at the harness side.
2. Turn the ignition switch to "ACC" position.
3. Voltage between terminal 1 and ground.
-
Voltage should be approximately 12 volts (battery positive voltage).
If not approximately 12 volts, go to Step 3.
If approximately 12 volts, go to Step 5.
STEP 3. Check the wiper motor connector A-03 for damage.
