Eclipse GT V6-3.0L SOHC (2000)
STEP 5. Check the wiper motor connector A-03 and front-ECU connector A-09X for damage.
If the wiper motor connector A-03 and front-ECU connector A-09X are damaged, repair or replace them. Refer to Harness Connector Inspection.
The windshield wiper should stop at the predetermined park position.
If the connectors are in good condition, go to Step 6.
STEP 6. Check the harness wires between wiper motor connector A-03 and front-ECU connector A-09X.
NOTE: After checking intermediate connector C-06, check the wires. If intermediate connector C-06 is damaged, repair or replace it. Refer to Harness
Connector Inspection.
If the harness wires between wiper motor connector A-03 and front-ECU connector A-09X are damaged, repair them. The windshield wiper should stop
at the predetermined park position.
Inspection Procedure G-4
TECHNICAL DESCRIPTION (COMMENT)
The ETACS-ECU calculates the intermittent wiper interval, and sends a signal to the front-ECU through the SWS communication line. If the signal is
defective, the front-ECU will ignore the signal and set the intermittent wiper interval to four seconds.