Eclipse GT V6-3.0L SOHC (2000)
STEP 4. Check the harness wires between backup light switch connector B-37 and ignition switch (IG1).
NOTE: After checking intermediate connector C-28 and junction block connectors C-101 and C-107, check the wires. If intermediate connector C-28
and junction block connectors C-101 and C-107 are damaged, repair or replace them. Refer to Harness Connector Inspection.
If the harness wires between backup light switch connector B-37 and ignition switch (IG1) are damaged, repair them.
The backup light switch input signal should be able to be checked and the rear wiper should work normally.
STEP 5. Check the backup light switch connector B-37 and ETACS-ECU connector C-111 for damage.
If the backup light switch connector B-37 and ETACS-ECU connector C-111 are damaged, repair or replace them. Refer to Harness Connector
Inspection.
The backup light switch input signal should be able to be checked and the rear wiper should work normally.
If the connectors are in good condition, go to Step 6.