Eclipse GT V6-3.0L SOHC (2000)
STEP 5. Check the park/neutral position switch connector B-41 and ETACS-ECU connector C-111 for damage.
If the park/neutral position switch connector B-41 and ETACS-ECU connector C-111 are damaged, repair or replace them. Refer to Harness Connector
Inspection. The park/neutral position switch "R" position signal should be able to be checked and the rear wiper should work normally.
If the connectors are in good condition, go to Step 6.
STEP 6. Check the harness wires between park/neutral position switch connector B-41 and ETACS-ECU connector C-111.
NOTE: After checking intermediate connector C-28, check the wires. If intermediate connector C-28 is damaged, repair or replace it. Refer to Harness
Connector Inspection.
If the harness wires between park/neutral position switch connector B-41 and ETACS-ECU connector C-111 are damaged, repair them.
The park/neutral position switch "R" position signal should be able to be checked and the rear wiper should work normally.
If the harness wires are in good condition, replace the ETACS-ECU.
The park/neutral position switch "R" position signal should be able to be checked and the rear wiper should work normally.
Inspection Procedure O-8
