Eclipse GT V6-3.0L SOHC (2000)
STEP 7. Check the harness wires between rear wiper motor connector F-07 and ETACS-ECU connector C-114.
NOTE: After checking intermediate connector F-24 and junction block connector C-113, check the wires. If intermediate connector F-24 and junction
block connector C-113 are damaged, repair or replace them. Refer to Harness Connector Inspection.
If the harness wires between rear wiper motor connector F-07 and ETACS-ECU connector C-114 are damaged, repair them.
The rear wiper motor auto-stop signal should be able to be checked and the rear wiper should stop at the predetermined park position.
If the harness wires are in good condition, replace the ETACS-ECU.
The rear wiper motor auto-stop signal should be able to be checked and the rear wiper should stop at the predetermined park position.
Inspection Procedure O-9