Eclipse GT V6-3.0L SOHC (2000)
If the harness wires are in good condition, replace the ETACS-ECU.
The input signal from the driver's door lock key cylinder switch should be able to be checked and the functions, which are described in the "Technical
Description (comment)," should work normally.
STEP 7. Check the passenger's door lock key cylinder switch ground circuit at passenger's door lock key cylinder switch connector E-06.
1. Disconnect passenger's door lock key cylinder switch connector E-06 and measure at the harness side.
2. Resistance between terminal 2 and ground.
-
Should be less than 2 Ohms.
If open circuit, go to Step 8.
If less than 2 Ohms. go to Step 10.
STEP 8. Check passenger's door lock key cylinder switch connector E-14 for damage.
If passenger's door lock key cylinder switch connector E-14 is damaged, repair or replace it. Refer to Harness Connector Inspection.
The input signal from the passenger's door lock key cylinder switch should be able to be checked and the functions, which are described in the
"Technical Description (comment)," should work normally.
If the connector is in good condition, go to Step 9.