Eclipse GT V6-3.0L SOHC (2000)
-
Damaged harness wires or connectors
DIAGNOSIS
Required Special Tools:
MB991223: Test Harness Set
MB991502: Scan Tool (MUT-II)
MB991529: Diagnostic Trouble Code Check Harness
STEP 1. Check the battery circuit at the ETACS-ECU connector C-114.
1. Disconnect the ETACS-ECU connector C-114 and measure at the junction block side.
2. Voltage between terminal 2 and ground.
-
Voltage should be approximately 12 volts (system voltage).
If not approximately 12 volts, go to Step 2.
If approximately 12 volts, replace the ETACS-ECU.
The functions, which are described in the "Technical Description (comment)," should work normally.
STEP 2. Check the ETACS-ECU connector C-114 for damage.
If the ETACS-ECU connector C-114 is damaged, repair or replace it. Refer to Harness Connector Inspection.
The functions, which are described in the "Technical Description (comment)," should work normally.
If the connector is in good condition, go to Step 3.