Eclipse GT V6-3.0L SOHC (2000)
Throttle Position Sensor: Testing and Inspection
THROTTLE POSITION SENSOR CHECK
Required Special Tool:
MB991348: Test Harness Set
Checking the Terminal Resistance
1. Disconnect the throttle position sensor connector.
2. Measure the resistance between throttle position sensor side connector terminals 1 and 4.
Standard value: 3.5 - 6.5 ohms
Normal Condition
3. Measure the resistance between throttle position sensor side connector terminals 1 and terminal 3.
Normal condition:
4. If the resistance is outside the standard value, or if it doesn't change smoothly, replace the throttle position sensor.
NOTE: After replacement, the throttle position sensor should be adjusted.