Eclipse GT V6-3.0L SOHC (2000)
Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and deployment.
INSTALLATION SERVICE POINTS
<A> PRE-INSTALLATION INSPECTION
Check the side impact sensor for dents, breakage and bending and measure the resistance between the terminals, even when installing a new side impact
sensor.
<B> SIDE IMPACT SENSOR INSTALLATION
WARNING: If the side impact sensor is not installed securely and correctly, the side air bag may not operate normally.
Securely connect the connector.
Post-Installation Operation
-
Quarter Trim, Lower Installation
-
Rear Sear Belt Installation
-
Rear Seat Cushion Installation
<C> POST-INSTALLATION INSPECTION
1. Reconnect the negative (-) battery cable.
2. Turn the ignition switch to "ON" position.
3. Does the "SRS" warning light illuminate for approximately seven seconds, and then remain off for at least five seconds after turning "OFF"?
4. If yes, the SRS system is functioning properly. If no, refer troubleshooting.
