Eclipse GT V6-3.0L SOHC (2000)
Side Air Bag Module: Testing and Inspection
WARNING:
1. Never attempt to disassemble or repair the air bag modules or clock spring. If faulty, replace it.
2. Do not drop the air bag modules or clock spring or allow contact with water, grease or oil. Replace it if a dent, crack, deformation or rust
is detected.
3. The air bag modules should be stored on a flat surface and placed so that the pad surface is facing upward. Do not place anything on top
of it.
4. Do not expose the air bag modules to temperatures over 93° C (200° F).
5. After deployment of an air bag, replace the clock spring with a new one.
6. Wear gloves and safety glasses when handling air bags that have already deployed.
7. An undeployed air bag module should only be disposed of in accordance with the procedures.
WARNING:
-
It any improper part is found during the following inspection, replace the front seatback assembly with a new one. Dispose of the old one
according to the specified procedure.
-
Never attempt to measure the circuit resistance of the air bag module (squib) even if you are using the specified tester. If the circuit
resistance is measured with a tester, accidental air bag deployment will result in serious personal injury.
1. Check the air bag module deployment section for dents or deformation.
2. Check connector for damage, terminals for deformation, and harness for binds.
