Eclipse GT V6-3.0L SOHC (2000)
5.
Loosen the flare nuts on each end of the tube, then remove the tube. Make sure the 0-ring on each end of the tube comes off with the tube.
NOTE:
Access the tube fitting on the driver's side of the steering rack through the opening in the left-side wheel well. The tube fitting toward the passenger's
side of the vehicle is accessed from under the vehicle.
6.
Check each end of the new oil feed tube to make sure there is an 0-ring. Position the new tube, start threading each flare nut then hand-tighten as
far down as possible.
7
Using the torque wrench, tighten both flare nuts on the new oil feed tube to 13 Nm (113 in-lbs).
8.
Reinstall the left front wheel.
9.
Complete the following INSPECTIONS:
a.
Make sure there is at least 25 mm clearance between the exhaust manifold mounted heat shield and the new power steering oil feed tube.
b.
Fill the power steering fluid reservoir.
c.
Lower the vehicle, start the engine, and turn the steering wheel to full left and right lock, checking for any abnormal noise or sticking.
d.
Check the newly installed tube for oil leaks.
