Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
1. Use a resin spatula to scrape off the double-sided tape.
2. Wipe the body surface and clean it with a shop moistened with isopropyl alcohol.
INSTALLATION SERVICE POINTS
>>A<< REAR PILLAR GARNISH INSTALLATION
1. Scrape off the double-sided tape with a resin spatula or gasket scraper.
2. Use a shop towel moistened with 3M(TM)AAD Part number 8906 or equivalent to wipe the protect molding surface.
CAUTION: Do not remove all of the residual adhesive.
3. Remove only a small portion of the residual adhesive.
CAUTION:
-
Always apply it evenly on the entire surface, because a lot or little will reduce its strength.
-
Do not touch the painted surface.
4. Affix the specified double-sided tape [3 mm (0.1 inch) wide and 5 mm (0.2 inch) thick].
