Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
NO: Repair the wiring harness. Check that the power windows work normally.
STEP 10. Check at power window main switch connector E-12 in order to check the power window main switch ground circuit.
1. Disconnect power window main switch connector E-12, and measure at the harness side.
2. Measure the resistance value between terminal 9 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 13.
NO: Go to Step 11.
STEP 11. Check power window main switch connector E-12 for damage.
Q: Is power window main switch connector E-12 in good condition?
YES: Go to Step 12.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the power windows work normally.