Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
Q: Does the measured voltage correspond with this range?
YES: Go to Step 10.
NO: Go to Step 8.
STEP 8. Check the sunroof motor assembly connector D-06 for damage.
Q: Is sunroof motor assembly connector D-06 in good condition?
YES: Go to Step 9.
NO: Repair or replace it. Refer to Harness Connector Inspection. The sunroof should work normally.
STEP 9. Check the harness wires between sunroof motor assembly connector D-06 and ignition switch (IG2).
NOTE: After checking junction block connectors C-102 and C-111, check the wires. If junction block connectors C-102 or C-111 are damaged, repair
or replace them. Refer to Harness Connector Inspection.
Q: Are the harness wires between sunroof motor assembly connector C-08 and ignition switch (IG2) in good condition?
YES: No action to be taken.
NO: Repair or replace them. The sunroof should work normally.
STEP 10. Check the sunroof motor assembly ground circuit at the sunroof motor assembly connector D-06.
1. Disconnect the sunroof motor assembly connector D-06 and measure at the harness side.