mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2032 > < Initial Inspection and Diagnostic Overview|Page 2030
Page 115
background image

3. Measure the voltage between terminal 30 and ground.

-

The measured value should be approximately 12 volts (battery positive voltage).

Q: Does the measured voltage correspond with this range?

YES: Replace the front-ECU. Check that the windshield wiper works normally.

NO: Go to Step 8.

STEP 8. Check the front-ECU connector A-11X for damage. 

Q: Is front-ECU connector A-11X in good condition?

YES: Go to Step 9.

NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the windshield wiper works normally.

Initial Inspection and Diagnostic Overview|Page 2032 > < Initial Inspection and Diagnostic Overview|Page 2030