Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
STEP 3. Check ETACS-ECU connector C-119, junction block connectors C-101, C-108 and C-112 for damage.
Q: Are ETACS-ECU connector C-119, junction block connectors C-101, C-108 and C-112 in good condition?
YES: Replace the ETACS-ECU. Check that the turn-signal lights illuminate normally.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the turn-signal lights illuminate normally.
STEP 4. Check at ETACS-ECU connector C-119 in order to check the power supply circuit to the ETACS-ECU (battery power supply).
1. Disconnect ETACS-ECU connector C-119, and measure at the junction block side.
2. Measure the voltage between terminal 11 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Replace the ETACS-ECU. Check that the turn-signal lights illuminate normally.
NO: Go to Step 5.
STEP 5. Check ETACS-ECU connector C-119 for damage.
Q: Is ETACS-ECU connector C-119 in good condition?
YES: Go to Step 6.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the turn-signal lights illuminate normally.