mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2167 > < Initial Inspection and Diagnostic Overview|Page 2165
Page 250
background image

NOTE:  Also check intermediate connectors C-06 and C-89. If intermediate connectors C-06 or C-89 /s damaged, repair or replace the connector as
described in Harness Connector Inspection.

Q: Are the wiring harnesses among fog light relay connector A-04X, fog light connectors A-28, A-31 and combination meter connector C-43 in good
condition?

YES: Go to Step 11.

NO: Repair the wiring harness. Check that the fog lights illuminate normally.

STEP 11. Replacement of ECU.

1. Replace the front-ECU.
2. The fog lights should illuminate normally.

Q: Do the fog lights illuminate normally?

YES: There is no action to be taken.

NO: Replace the ETACS-ECU. The fog light should illuminate normally.

Inspection Procedure L-2

Fog Light: Fog Lights do not Go Out when the Headlights (Low-beam) are Turned Off while the Fog lights are On.

TECHNICAL DESCRIPTION (COMMENT)

If the trouble above occurs, the front-ECU may be defective.

TROUBLESHOOTING HINT

Malfunction of the front-ECU

DIAGNOSIS

Replace the front-ECU.

The fog lights should go out when the headlights (low-beam) are turned off while the fog lights are on.

Inspection Procedure L-3

Fog Light: One of the Fog Lights does not Illuminate.

Initial Inspection and Diagnostic Overview|Page 2167 > < Initial Inspection and Diagnostic Overview|Page 2165