Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
STEP 7. Check the wiring harness between dome light connector D-04 <ECLIPSE-vehicles without sunroof>, D-03 <ECLIPSE SPYDER,
ECLIPSE-vehicles with sunroof, without vanity mirror light> or D-25 <ECLIPSE-vehicles with sunroof and vanity mirror light> and
ETACS-ECU connector C-119.
NOTE: Also check junction block connector C-102. If junction block connector C-102 is damaged, repair or replace the connector as described in
Harness Connector Inspection.
Q: Is the wiring harness between dome light connector D-04 <ECLIPSE-vehicles without sunroof>, D-03 <ECLIPSE SPYDER, ECLIPSE-vehicles with
sunroof, without vanity mirror light> or D-25 <ECLIPSE-vehicles with sunroof and vanity mirror light> and ETACS-ECU connector C-119 in good
condition?
YES: Replace the ETACS-ECU. Check that the dome light illuminates normally.
NO: Repair the wiring harness. Check that the dome light illuminates normally.
STEP 8. Check the luggage compartment light bulb.
Q: Is the luggage compartment light bulb in good condition?
YES: Go to Step 9.
NO: Replace the bulb. Check that the luggage compartment lights illuminate normally.
STEP 9. Measure at luggage compartment light connector F-21 in order to check the ETACS-ECU line of the power supply to the luggage
compartment light.
1. Disconnect luggage compartment light connector F-21, and measure at the wiring harness side.
2. Measure the voltage between terminal 1 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).