Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 5.
NO: Go to Step 3.
STEP 3. Check fog light switch connector C-76 for damage.
Q: Is fog light switch connector C-76 in good condition?
YES: Go to Step 4.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Repair the fog light switch. If the for light switch operates normally, it
indicates that a correct signal is sent from the fog light switch.
STEP 4. Check the wiring harness between fog light switch connector C-76 and ground.
NOTE: Also check joint connector C-78. If joint connector C-78 is damaged, repair or replace the connector as described in Harness Connector
Inspection.
Q: Is the wiring harness between fog light switch connector C-76 and the ground in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. If the for light switch operates normally, it indicates that a correct signal is sent from the fog light switch.