Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
11. Check that the A/T fluid level is at the "COLD" mark on the dipstick. If the level is lower than this, pour in more A/T fluid.
12. Drive the vehicle until the A/T fluid temperature rises to the normal temperature [70 - 80°C (158 - 176°F)], and then check the A/T fluid level
again. The A/T fluid level must be at the "HOT" mark.
NOTE: The ACT fluid temperature is measured with scan tool (MUT-II)
NOTE: The "COLD" level is for reference only; the "HOT" level should be regarded as the standard level.
NOTE: If it takes some amount of time until the A/T fluid reaches As normal operating temperature [70 - 80°C (158 - 176°F)], check the A/T
fluid level.
13. When A/T fluid is under the specified level, pour in more A/T fluid. When A/T fluid is under the specified level, drain the excessive A/T fluid
from the drain plug to adjust A/T fluid level to the specified level.
14. Firmly insert the dipstick into the oil filler tube.