Eclipse Spyder FWD L4-2350cc 2.4L SOHC 16 Valve (1996)
1. Position rack at its center. Tighten rack support cover to 15 Nm (11 ft. lbs.).
2. In neutral position, rotate pinion shaft clockwise one turn/4-6 seconds with special tool. Return rack support cover 30-60 and adjust torque
to the standard value.
3. Using the special tools, rotate the pinion gear at the rate of one rotation in approximately 4 to 6 seconds to check the total pinion torque.
Standard value: 0.7-1.4 Nm (6-12 inch lbs.)
[Change in torque: 0.4 Nm (3 inch lbs.)]
CAUTION:
-
When adjusting, set the standard value at its highest value.
-
Assure no ratcheting or catching when operating rack towards the shaft direction.
NOTE: When it cannot be adjusted within the specified return angle, check rack support cover components or replace.
4. After adjusting, lock rack support cover with lock nut.
n. Tab washer/tie rod installation (8 & 9).
After installing tie rod to rack, fold tab washer end (2 locations) to tie rod notch.
o. Bellows band installation (6).
1. Touch pliers against the concave section of the bellows band and tighten the bellows band.
