Eclipse Spyder GS-T L4-1997cc 2.0L DOHC Turbo MFI (1998)
CAUTION: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
2. Remove Air bag module (Driver's side)
Pre-installation Inspection
1. When installing the new air bag module and clock spring, refer to "INSPECTION".
CAUTION: Dispose of an air bag module only according to the specified procedure.
2. Connect the battery (-) terminal.
3. Connect the scan tool to the data link connector, then check diagnostic codes.
CAUTION: Turn the ignition switch off before disconnecting or connecting the scan tool.
4. Turn the ignition key to the "ON" position.
5. Conduct diagnostic test mode using the scan tool to ensure entire SRS operates properly, except open circuit of air bag module (diagnostic trouble
code No.22, 25).
6. Turn the ignition key to the "LOGIC" position, disconnect the negative battery cable and tape the terminal to prevent accidental connection and air
bags deployment.
CAUTION: Wait at least 60 seconds after disconnecting the battery cable before doing any further work. (Refer to Service Precautions)
Installation
To install reverse the removal steps and note the following.
Air Bag Module (Driver's Side)
2. Air Bag Module (driver's Side) Installation
Install the air bag module, taking care that the wiring is not pinched.