Eclipse Spyder GT V6-3.0L SOHC (2002)
STEP 3. Check the power window relay.
Q: Is the power window relay normal?
YES: Go to Step 4.
NO: Replace the power window relay. Check that the power windows work normally.
STEP 4. Measure at power window relay connector C-116 in order to check the fusible link (5) line of power supply system to power window
relay.
1. Disconnect power window relay connector C-116, and measure at the junction block side.
2. Measure the voltage between terminal 5 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 7.
NO: Go to Step 5.