Eclipse Spyder GT V6-3.0L SOHC (2002)
STEP 7. Measure at power window relay connector C-116 in order to check the ground system to the power window relay.
1. Disconnect power window relay connector C-116, and measure at the junction block side.
2. Measure the resistance value between terminal 3 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 10.
NO: Go to Step 8.
STEP 8. Check power window relay connector C-116 for damage.
Q: Is power window relay connector C-116 in good condition?
YES: Go to Step 9.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the power windows work normally.
STEP 9. Check the wiring harness between power window relay connector C-116 and ground.
NOTE: Also check junction block connector C-108. If junction block connector C-108 is damaged, repair or replace the connector as described in
Harness Connector Inspection.
Q: Is the wiring harness between power window relay connector C-116 and ground in good condition?
YES: No action to be taken.