mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2152 > < Initial Inspection and Diagnostic Overview|Page 2150
Page 120
background image

STEP 2. Check the windshield wiper motor.

1. Disconnect windshield wiper motor connector A-03.
2. Connect a battery to the windshield wiper motor as shown. 

Then check the windshield wiper motor operates normally at high and low speeds.

Q: Does the windshield wiper motor operate normally?

YES: Go to Step 3.

NO: Replace the windshield wiper motor. Check that the windshield wiper operates normally when the windshield wiper switch is moved to
each position.

STEP 3. Check windshield wiper motor connector A-03 and front-ECU connector A-11X for damage. 

Q: Are windshield wiper motor connector A-03 and front-ECU connector A-11X in good condition?

YES: Go to Step 4.

NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the windshield wiper operates normally when the windshield
wiper switch is moved to each position.

Initial Inspection and Diagnostic Overview|Page 2152 > < Initial Inspection and Diagnostic Overview|Page 2150