Eclipse Spyder GT V6-3.0L SOHC (2002)
Connectors
TECHNICAL DESCRIPTION (COMMENT)
If the high-beam indicator light does not illuminate, the high-beam indicator light bulb or the ETACS-ECU may be defective.
TROUBLESHOOTING HINTS
-
Malfunction of the high-beam indicator light bulb
-
Malfunction of the ETACS-ECU
-
Damaged harness wires or connectors
DIAGNOSIS
Required Special Tools:
MB991223: Test Harness Set
STEP 1. Check the headlight operation.
Q: Do the headlights illuminate?
YES: Go to Step 2.
NO: Repair the headlights first (Refer to Inspection Procedure J-3).
STEP 2. Check at ETACS-ECU connector C-118 in order to check the high-beam indicator light circuit.
1. Disconnect ETACS-ECU connector C-118, and measure at the wiring harness side.
2. Turn the ignition switch to the "ON" position.
3. Connect terminal No.72 to ground.