Eclipse Spyder GT V6-3.0L SOHC (2002)
STEP 3. Check the fog light relay.
Q: Is the fog light relay in good condition?
YES: Go to Step 4.
NO: Replace the fog light relay. Check that the fog lights illuminate normally.
STEP 4. Measure at fog light relay connector A-04X in order to the battery power supply to the fog light relay.
1. Disconnect fog light relay connector A-04X, and measure at the relay box side.
2. Measure the voltage between terminal 1.2 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 7.
NO: Go to Step 5.