Eclipse Spyder GT V6-3.0L SOHC (2002)
NOTE: Also check intermediate connectors C-06 and C-89. If intermediate connectors C-06 or C-89 /s damaged, repair or replace the connector as
described in Harness Connector Inspection.
Q: Are the wiring harnesses among fog light relay connector A-04X, fog light connectors A-28, A-31 and combination meter connector C-43 in good
condition?
YES: Go to Step 11.
NO: Repair the wiring harness. Check that the fog lights illuminate normally.
STEP 11. Replacement of ECU.
1. Replace the front-ECU.
2. The fog lights should illuminate normally.
Q: Do the fog lights illuminate normally?
YES: There is no action to be taken.
NO: Replace the ETACS-ECU. The fog light should illuminate normally.
Inspection Procedure L-2
Fog Light: Fog Lights do not Go Out when the Headlights (Low-beam) are Turned Off while the Fog lights are On.
TECHNICAL DESCRIPTION (COMMENT)
If the trouble above occurs, the front-ECU may be defective.
TROUBLESHOOTING HINT
Malfunction of the front-ECU
DIAGNOSIS
Replace the front-ECU.
The fog lights should go out when the headlights (low-beam) are turned off while the fog lights are on.
Inspection Procedure L-3
Fog Light: One of the Fog Lights does not Illuminate.