Eclipse Spyder GT V6-3.0L SOHC (2002)
STEP 2. Check the input signal by using service data of the SWS monitor.
Check the input signals from the following switches:
-
Ignition switch: ON or START
-
Driver's and front passenger's door: open.
Select "ETACS-ECU" (DATA LIST), and check that normal conditions are displayed on the items described in the table.
Q: Does the scan tool display the items "IG SW (IG1)". "DR DOOR SW" and "PASS DOOR SW" as normal condition?
YES: Go to Step 3.
NO:
-
The scan tool does not show the respective normal condition for item "IG SW (IG1)." Refer to Inspection Procedure O-2 "ETACS-ECU does not
receive a signal from the ignition switch (IG1)."
-
The scan tool does not show the respective normal condition for item "DR DOOR SW" and "PASS DOOR SW." Refer to Inspection Procedure
O-6 "ETACS-ECU does not receive a signal from the driver's or the front passenger's door switch."
STEP 3. Check the input signal (by using the Pulse Check).
Check the following switches and input signals:
-
Key reminder switch