Eclipse Spyder GT V6-3.0L SOHC (2002)
STEP 6. Check the wiring harness between park/neutral position switch connector B-41 and ETACS-ECU connector C-117.
NOTE: Also check intermediate connector C-28. If intermediate connectors C-28 is damaged, repair or replace the connector as described in Harness
Connector Inspection.
Q: Is the wiring harness between park/neutral position switch connector B-41 and ETACS-ECU connector C-117 in good condition?
YES: Replace the ETACS-ECU. If the rear wiper operates normally, it indicates that a correct "R" position signal is sent from the park/neutral
position switch.
NO: Repair the wiring harness. If the rear wiper operates normally, it indicates that a correct "R" position signal is sent from the park/neutral position
switch.
Inspection Procedure O-6
The ETACS-ECU does not Receive Any Signal from the Driver's or the Front Passenger's Door Switch.
NOTE: This troubleshooting requires use of scan tool MB991502 and SWS monitor kit MB991862. For details of how to use the SWS monitor, refer
to "How to use SWS monitor."