Eclipse Spyder GT V6-3.0L SOHC (2002)
STEP 2. Malfunction of the driver's door lock key cylinder switch
Disconnect driver's door lock key cylinder switch connector E-14.Then check continuity between the switch terminals.
Q: Is the driver's door lock key cylinder switch in good condition?
YES: Go to Step 3.
NO: Replace the driver's door lock key cylinder switch. If the systems, which are described in "CIRCUIT OPERATION", work normally, the input
signal from the driver's door lock key cylinder switch should be normal.
STEP 3. Measure at driver's door lock key cylinder switch connector E-14 in order to check the ground circuit to the driver's door lock key
cylinder switch.
1. Disconnect driver's door lock key cylinder switch connector E-14, and measure at the harness side.
2. Measure the resistance value between terminal 2 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 6.
NO: Go to Step 4.
STEP 4. Check driver's door lock key cylinder switch connector E-14 for damage.
Q: Is driver's door lock key cylinder switch connector E-14 in good condition?
YES: Go to Step 5.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the systems, which are described in "CIRCUIT OPERATION", work
normally, the input signal from the driver's door lock key cylinder switch should be normal.
