Eclipse Spyder GT V6-3.0L SOHC (2002)
WARNING: The side-airbag modules for both the drivers side and passenger's side should be deployed.
3. To deploy the side-airbag module: Remove the connection between the side-airbag module connector (red two-pin) and the floor wiring harness
connector.
NOTE: If the side-airbag module connector is disconnected from the floor wiring harness, both electrodes of the air bag module connector will be
automatically shorted to prevent unintended deployment of the air bag due to static electricity, etc.
4. Connect deployment wires, each 6 meters (20 feet) or longer, to the two leads of special tool MB686560, and cover the connections with
insulation tape. The other ends of the deployment wires should be connected to each other (short circuited), to prevent sudden unexpected
deployment of the air bag module.
5. Connect the side-airbag module two-pin connector to special tool MB686560 and move the deployment wires out of the vehicle.
WARNING: If the glass is scratched, air bag deployment could cause it to crack and fly out of the vehicle, so always put a cover over the
vehicle.
6. To suppress the operation sound as much as possible completely close all door windows, close the doors and put the vehicle.
WARNING:
-
Before deploying the air bag in this manner, first check to be sure that there is no one in or near the vehicle. Wear safety glasses.
