Endeavor V6-3.8L SOHC (2004)
Technical Service Bulletin # SR-05-001R
Date: 050401
Recall - Park Brake Cable Lock Nut Torque
No.: SR-05-001REV
DATE: April, 2005
Model:
2004-05 Endeavor
SUBJECT:
PARKING BRAKE CABLE LOCK NUTS - SAFETY RECALL CAMPAIGN
This bulletin supercedes SR-05-001, issued March, 2005, to correct the lock nut inspection and part number information. Revised information is
indicated by >.
PURPOSE
The parking brake cable lock nuts on some affected vehicles may not have been tightened to the proper torque specification. If not tightened properly,
the nuts may loosen and come off, reducing the effectiveness of the parking brake. This condition could allow the vehicle to roll if the transmission is not
in "Park" and the vehicle is parked on a slope, increasing the possibility of a crash.
> Dealers should inspect the parking brake cable lock nut torque as described in this bulletin, replacement is only necessary if the nut is missing or
damaged.
AFFECTED VEHICLES
2004-05 Endeavor models produced between 3/11/04 and 1/7/05
IMPORTANT
Affected new or used inventory vehicles must be inspected/repaired before the vehicle is sold. This includes vehicles recently acquired at Mitsubishi
auctions. Dealers must check their inventory vehicles' VINs on the Warranty Super Screen to verify whether the vehicle is an affected VIN for this
recall campaign.
CUSTOMER NOTIFICATION
A letter will be sent to all owners of affected vehicles, asking them to bring their vehicle to their Mitsubishi dealer to have the parking brake cable lock
nuts inspected. A copy of the customer notification letter is shown in this bulletin.
REQUIRED OPERATIONS
Before starting this campaign procedure, CHECK ON THE WARRANTY SUPER SCREEN to verify that the vehicle is an affected VIN for this
campaign and that this campaign procedure has not already been completed.
1.
Release the parking brake.