mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Relays and Modules - Steering and Suspension > < Seat Belt Control Module|Testing and Inspection|Page 188
Page 2
background image

DANGER:  Wait at least 60 seconds after disconnecting the battery cable before doing any further work (Refer to Service Precautions).

WARNING:  Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.

Disconnect the negative battery cable from the battery and tape the terminal to prevent accidental connection and deployment.

INSTALLATION SERVICE POINTS

]]A[[ SRS-ECU INSTALLATION

WARNING:  The SRS may not activate if the SRS-ECU is not installed properly, which could result in serious injury or death to the vehicle's
driver or front passenger.

]]B[[ POST-INSTALLATION INSPECTION

1. Reconnect the negative (-) battery cable.
2. Turn the ignition switch to the "ON" position.

3. Does the "SRS" warning light illuminate for approximately seven seconds, and then go out?
4. If yes, the SRS system is functioning properly. If not, refer to Air Bag Systems/Supplemental Inflatable Restraint Lamp/Indicator.

Relays and Modules - Steering and Suspension > < Seat Belt Control Module|Testing and Inspection|Page 188