Endeavor 2WD V6-3.8L (6G75) (2008)
Removal Steps 1-16 (Part 2)
REMOVAL SERVICE POINT
[[A]] FUEL HIGH-PRESSURE HOSE DISCONNECTION
CAUTION: Do not kink the fuel high-pressure hose as it is made of plastics.
1. Insert a flat-tipped screwdriver [width 6 mm (0.24 inch), thickness 1 mm (0.04 inch)] to the retainer.
2. Turn the flat-tipped screwdriver approximately 90 degrees to the arrowed direction, and lift the retainer to unlock and disconnect the fuel
high-pressure hose.
[[B]] FUEL RAIL AND FUEL INJECTOR ASSEMBLY REMOVAL
CAUTION: Care must be taken when removing the fuel rail not to drop the injector.
Remove the fuel rail with the injectors attached to it.
INSTALLATION SERVICE POINTS
]]A[[ INTAKE MANIFOLD GASKET INSTALLATION