Endeavor 2WD V6-3.8L (6G75) (2008)
1. Disconnect powertrain control module connector B-18 and ABS/TCL-ECU connector A-02, and measure the voltage at the harness side of
powertrain control module connector B-18.
2. Turn the ignition switch to the "ON" position.
3. Measure the voltage between powertrain control module connector terminal 17 and body ground.
OK: 1.0 V or less
CAUTION: Strictly observe the specified wiring harness repair procedure.
Q: Does the voltage measure 1.0 V or less?
YES : [The voltage measures 1.0 V or less] Go to Step 26.
NO : [The voltage measures more than 1.0 V] Repair the wiring harness between powertrain control module connector and ABS/TCL-ECU
connector.
Part 2