Endeavor 2WD V6-3.8L (6G75) (2008)
-
A digital multimeter should be used.
-
The test wiring harness should be used.
1. Disconnect intermediate connector C-24 and G and yaw rate sensor connector C-36, and measure the voltage at the wiring harness side of
intermediate connector male side (at front wiring harness side).
2. Turn the ignition switch to the "ON" position.
3. Measure the voltage between intermediate connector terminal 4 and body ground.
OK: 1.0 V or less
CAUTION: Strictly observe the specified wiring harness repair procedure.
Q: Does the voltage measure 1.0 V or less?
YES : [The voltage measures 1.0 V or less] Go to Step 54.
NO : [The voltage measures more than 1.0 V] Repair the wiring harness between intermediate connector C-24 and the G and yaw rate sensor
connector.
STEP 54. Check the CAN_L line (communication line only) between intermediate connector C-24 and joint connector (4) for a short to the
power supply. Measure the voltage at joint connector (4) C-101.
CAUTION:
-
A digital multimeter should be used.
-
The test wiring harness should be used.