Endeavor 2WD V6-3.8L (6G75) (2008)
4. Measure the resistance between joint connector (4) terminals 21 and body ground.
OK: 1 kohm or more
Q: Does the resistance measure 1 kohm or more?
YES : If the resistance measures 1 kohm or more, go to Step 58.
NO : If the resistance measures less than 1 kohm, go to Step 49.
STEP 49. Check TPMS receiver connector C-118 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
CAUTION: The strand end of the twisted wire should be within 10 cm (4 inches) from the connector.
Q: Is TPMS receiver connector C-118 in good condition?
YES : Go to Step 50.
NO : Repair the damaged parts.
STEP 50. Check the CAN_L line (communication line only) between joint connector (4) and TPMS receiver connector for short to ground.
Measure the resistance at joint connector (4) C-101.
CAUTION:
-
A digital multimeter should be used.
-
The test wiring harness should be used.