Endeavor 2WD V6-3.8L (6G75) (2008)
YES : [All the resistances measure 2 ohms or less] Go to Step 8.
NO : [If either of the resistances measures more than 2 ohms or all the resistances measure more than 2 ohms] Replace the ASC/TCL-ECU.
Step 15. Check the CAN bus lines (communication line only) between joint connector (4) and the data link connector. Measure the resistance at
joint connector (4) C-101 and data link connector C-121.
CAUTION:
-
A digital multimeter should be used.
-
The test wiring harness should be used.
1. Disconnect joint connector (4), and measure the resistance between the wiring harness side connector of joint connector (4) and wiring harness
side connector of data link connector C-121.
2. Turn the ignition switch to the "LOCK" (OFF) position.
CAUTION: Disconnect the negative battery terminal.
3. Disconnect the negative battery terminal.