Expo LRV AWD L4-1834cc 1.8L SOHC 16 Valve (1992)
Power Window Motor: Technical Service Bulletins
Power Window - Motor & Regulator Assembly Procedures
NO. TSB-97-42A-003
DATE: February, 1997
MODEL: See Below
PURPOSE
In the past, the power window motor and regulator were supplied as a complete unit for replacement parts. For listed models the motor and regulator are
now available separately. The affected service manuals do not include instructions for motor and regulator assembly or drum and regulator wire
assembly. Use the instructions in this bulletin along with those in the service manual when replacing the power window motor and/or regulator.
AFFECTED VEHICLES
1992-97 Montero
1992-95 Expo/Expo LRV
AFFECTED MANUALS
The following manuals do not include the procedures covered in this bulletin for power window motor/regulator assembly and drum and regulator wire
assembly.
1992-95 Montero Service Manual Volume 1
1996 Montero Service Manual Volume 1
1997 Montero Service Manual Volume 1
1992-96 Expo/Expo LRV Service Manual Volume 1
PROCEDURE
^
POWER WINDOW MOTOR AND REGULATOR ASSEMBLY
CAUTION
Be careful when handling the power window motor. otherwise, the wire may come off the drum due to the reaction force of the spring.
1.
The new part comes with a tie-wrap to hold the assembly together during shipping. This tie must be removed before proceeding. While holding the
case and metallic cover by hand, cut off the tie-wrap with side cutters or similar tool.
2.
Remove the metallic cover.
Note:
If the wire has come off of the drum, restore the wire according to the DRUM AND REGULATOR WIRE ASSEMBLY procedures elsewhere in this
bulletin.
3.
Using the guide and motor housing opening and drum housing guide tab as assembly reference points, align the drive shaft of the power window
