Expo LRV AWD L4-2350cc 2.4L SOHC 16 Valve (1993)
![background image](/mitsubishi/expo_lrv_awd/l4-2350cc_2.4l_sohc_16_valve/Page-371001.png)
Crankshaft Position Sensor: Service and Repair
Crankshaft and Camshaft (TDC) Position Sensor
Distributor Exploded View
NOTE:Crankshaft Position / Camshaft (TDC) Sensor are replaced as a complete unit.
REMOVAL:
1. Disconnect battery ground cable.
2. Remove distributor cap retaining screws and seal ring.
3. Place No. 1 cylinder to TDC of compression stroke. Place a mark on distributor body indicating position of rotor.
4. Disconnect wiring harness from distributor lead wire.
5. Remove distributor mounting nuts, then the distributor assembly from engine.
INSTALLATION:
1. Turn the crankshaft so that the No.1 cylinder is at top dead center.
Distributor Drive Gear Alignment
2. Align the distributor housing and gear mating marks.