FE120 L4-4.9L DSL Turbo (2005)
#582 Inspection of injector magnetic valve
-
Measure the resistance between terminals 1 and 2.
Standard value (at 20 °C {68 °F}) 0.255 ± 0.04 ohms
-
If the measurement is out of specification, replace the injector.
#828 Inspection of fuel injection rate adjustment resistor
-
Measure the resistance of the resistor number marked on the fuel injection rate adjustment resistor.
-
If the measurement IS out of specification, replace the fuel injection rate adjustment resistor with one that has the same resistor number and same
specified resistance.
CAUTION: The fuel injection rate adjustment resistor is matched to the engine. If you replace it, be sure to replace it with one that has the
same resistor number.