FE639 L4-3.9L DSL Turbo (1998)
-
Remove union nut 4 of the injection pipe, delivery valve holder 5, stopper 6, delivery valve spring 7 and delivery valve 8 from the injection pump
of NO.1 cylinder.
-
After removing these parts, install delivery valve holder 5.
CAUTION: Be sure to keep all the removed parts in diesel fuel to keep them free from dirt.
-
Mount extra injection pipe 9 on NO.1 cylinder. Direct the free end the pipe downwards so that the fuel discharge can be c1ealy of served.
A: Oil tray
-
Turn the crankshaft more than 180° in the direction of engine rotation and bring NO.1 cylinder to approximately 30° before top dead center the
compression cycle.
NOTE: Refer to the location where there are 30° gradations, since angle gradations on the crankshaft pulley side only extend to 20°.