Galant L4-1997cc 2.0L DOHC (1990)
Main Relay (Computer/Fuel System): Description and Operation
Power Supply Circuit
The control relay, located in front of the center console, is both and input and output device for the ECU. It supplies the positive circuit to the
EGR and purge solenoids, air flow sensor, ECU and injectors. The operation of the fuel pump is controlled by the ECU through the Control Relay.
While cranking, positive current (supplied by the ignition switch "START" position) flows through coil L2 to close switch S1. As a result, the fuel
pump is energized. Additionally, positive current (supplied by the ignition switch "ON" position) flows through coil L3 to close switch S2. As a
result, positive current is supplied to the ECU, Air Flow Sensor (AFS), injectors, EGR solenoid, Purge Control solenoid and the L1 coil of the S1
switch. After the engine starts and the key is returned to the "ON" position, the ECU provides the ground to the L1 coil, thus allowing the battery
current to close switch S1. As a result the fuel pump continues to be supplied power, but is now under the full control of the ECU. In the event of
engine stall or other abnormal conditions, the ECU interrupts the ground, opening the L1 coil and interrupting the fuel pump power circuit.
NOTE: Failure of the control relay may interrupt power supply to the fuel pump, injectors and/or the ECU, resulting in start failure.
