Galant L4-1997cc 2.0L DOHC (1990)
a. Support rear suspension assembly using a suitable transmission jack.
b. Remove self locking nuts and crossmember brackets.
c. Hold stabilizer link then remove link self locking nut.
d. Lower rear suspension slightly to make a gap between the rear suspension and the body.
e. remove stabilizer bar assembly.
3.
Reverse procedure to install, noting the following:
a. Hold stabilizer ball studs and install self locking nut (A), Fig. 11.
b. Holding stabilizer link, tighten self locking nut (B) so that the protrusion of stabilizer link is .354-.433 inch.
