Galant L4-1997cc 2.0L SOHC 16 Valve (1993)
B. TAPER ROLLER BEARING REMOVAL
CAUTION:
-
Do not reuse the bearing removed from the shaft.
-
Replace the inner and outer races of the taper roller bearing as a set.
C. LOCK PIN REMOVAL
(1) Drive out the lock pin from the hole A using a punch.
REASSEMBLY SERVICE POINTS
A. SPACER / SIDE GEAR /WASHER / PINION / PINION SHAFT INSTALLATION
(1) Install the spacer on the back of the side gear and then install the gear in the differential case.
CAUTION: When installing a new side gear, use a spacer of medium thickness [0.93-1.00 mm (.366 - .394 in.)].
(2) Set the washer on the back of each pinion and insert the two pinions to specified position while engaging them with the side gears and turning
them.
(3) Insert the pinion shaft.