Galant L4-2.0L SOHC (1989)
Install the ball bearing over the input shaft using the special tool.
4. INSTALLATION OF SNAP RING
Install a snap ring so that the input shaft rear bearing end play will be the standard value.
Standard value: 0.01 - 0.09 mm (0.0004 - 0.004 in.)
3. INSTALLATION OF BEARING SLEEVE
Using special tool, attach the bearing sleeve on the input shaft.
CAUTION: When press-fitting the sleeve on the input shaft, verify that the flange of the sleeve fits closely on the bearing.
2. INSTALLATION OF BALL BEARING