Galant V6-3.0L SOHC (2003)
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. The theft-alarm indicator light should illuminate, and the theft-alarm system should be set normally.
STEP 9. Check the input signal by using "DATA LIST" menu of the SWS monitor.
Satisfy the following conditions to check the driver's and front passenger's door switches.
-
Driver's door: Open (driver's door switch is on) However, the door should be closed when checking the front passenger's door switch.
-
Front passenger's door: Open (front passenger's door switch is on)
However, the door should be closed when checking the driver's door switch.
1. Connect scan tool MB991502 to the data link connector.
2. Connect SWS monitor kit MB991862 to the column switch connector.
3. Operate scan tool MB991502 according to the procedure below to display "ETACS ECU."
1. Select "SYSTEM SELECT."
2. Select "SWS."
3. Select "SWS MONITOR."
4. Select "DATA LIST."
5. Select "ETACS ECU."
4. The scan tool should show the above values when each switch is operated.
NOTE: The scan tool display changes when the driver's or the front passenger's door is opened. If any of the doors is open, the system can not be
checked correctly.
Q: Does the scan tool show the respective normal condition for item "FRONT DOOR SW."
YES: Go to Step 10.
NO: Refer to Inspection Procedure M-4 "ETACS-ECU does not receive any signal from the driver's or front passenger's door switch."