Galant V6-3.0L SOHC (2003)
8. Fill a sealant gun with adhesive. Then apply the adhesive evenly around the windshield within 30 minutes after applying the primer.
9. Align the mating marks on the windshield and the body, and lightly press the windshield evenly so that it adheres completely.
10. Use a spatula or similar tool to remove any excessive adhesive. Clean the surface with 3M(TM) AAD Part number 8906 or equivalent. Avoid
moving the vehicle until the adhesive sets.
CAUTION:
-
Do not move the vehicle unless absolutely necessary.
-
When testing for water leakage, do not pinch the end of the hose to spray the water.
11. Wait 30 minutes or more, and then test for water leakage.
>>D<< ROOF DRIP MOLDING INSTALLATION
Install the clip to the roof drip molding before installing the molding to the vehicle body.