mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2820 > < Initial Inspection and Diagnostic Overview|Page 2818
Page 126
background image

indicator light should illuminate, and the theft-alarm system should be armed normally.
If the two resistance values are much the same, go to Step 5.

STEP 5. Check the combination meter connector C-30 and ETACS-ECU connector C-81 for damage.

If the combination meter connector C-30 and ETACS-ECU c9nnector C-81 are damaged, repair or replace them. Refer to Harness Connector Inspection.

The "SECURITY" indicator light should illuminate, and the theft-alarm system should be armed normally.

If the connectors are in good condition, got to Step 6.

STEP 6. Check the harness wire between combination meter connector C-30 and ETACS-ECU connector C-81.

If the harness wire between combination meter connector C-30 and ETACS-ECU connector C-81 is damaged, repair it.

The "SECURITY" indicator light should illuminate, and the theft-alarm system should be armed normally.

If the harness wire is in good condition, go to Step 7.

Initial Inspection and Diagnostic Overview|Page 2820 > < Initial Inspection and Diagnostic Overview|Page 2818